南海北部陆坡天然气水合物成藏特征研究进展分析

南海北部陆坡区域构造地质控制着气源、流体疏导体系、富集空间及储层物性特征,因此,东沙海域、神狐海域、西沙海槽和琼东南盆地的水合物成藏条件及控制因素具有明显差异性。东沙海域深部气体可沿断层、裂缝、不整合面、砂岩疏导层和气烟囱等通道向上运移,并形成天然气水合物,具有渗漏型水合物产出特征;神狐海域水合物成藏与规模巨大的泥底辟活动相关,并与布莱克海台天然气水合物产出特征具有相似性;琼东南盆地中央坳陷带内为天然气水合物发育的重点区,底辟、泥火山或麻坑构造与天然气水合物发育密切相关。     

Analysis and assessment of a nanoparticle seeded small scale absorption refrigeration system driven by a low‐grade waste heat source

The thermoeconomic behaviour of a nanoparticle seeded single effect LiBr‐H₂O absorption refrigeration system (ARS) is investigated for a small scale application. In the proposed method, alumina nanoparticles with volume concentrations of 3%, 5%, and 7% are dispersed into an aqua lithium bromide solution. The multiobjective heat transfer search algorithm is employed to examine the design trade‐off between the coefficient of performance (COP) and total annualized cost (TAC). To analyze the overall performance of the system, the influence of five design parameters, namely the temperatures of the generator, absorber, evaporator, condenser and heat exchanger pipe diameter, are studied. It is found that with an increase in the COP, the TAC of the system is initially raised marginally, and after that, raised rigorously with further increment. The comparative results indicate that the COP and TAC of the nanofluid based ARS system are increased by about 7% and decreased by about 3.2%, respectively, corresponding to the Pareto points of the base ARS system. A lower break‐even point of about 2.6 years is achieved for the ARS system containing nanoparticles compared to the base ARS system. Overall, the ARS system containing 5% nanoparticles is the best solution from a thermodynamic and economic point of view.     

Jaya Learning-Based Optimization for Optimal Sizing of Stand-Alone Photovoltaic,Wind Turbine,and Battery Systems

Renewable energy sources (RESs) are considered to be reliable and green electric power generation sources. Photovoltaics (PVs) and wind turbines (WTs) are used to provide electricity in remote areas. Optimal sizing of hybrid RESs is a vital challenge in a stand-alone environment. The meta-heuristic algorithms proposed in the past are dependent on algorithm-specific parameters for achieving an optimal solution. This paper proposes a hybrid algorithm of Jaya and a teaching–learning-based optimization (TLBO) named the JLBO algorithm for the optimal unit sizing of a PV–WT–battery hybrid system to satisfy the consumer’s load at minimal total annual cost (TAC). The reliability of the system is considered by a maximum allowable loss of power supply probability (LPSP_max) concept. The results obtained from the JLBO algorithm are compared with the original Jaya, TLBO, and genetic algorithms. The JLBO results show superior performance in terms of TAC, and the PV–WT–battery hybrid system is found to be the most economical scenario. This system provides a cost-effective solution for all proposed LPSP_max values as compared with PV–battery and WT–battery systems.     

How vloggers embrace their viewers: Focusing on the roles of para-social interactions and flow experience

Social media allow marketers to directly influence consumers through a diverse set of tools. The characteristics of individual platforms enable the development of creative and innovative strategies for social media marketing. This study aims at examining para-social interactions (PSI), their antecedents (i.e., attitude homophily and physical attractiveness), and their consequences (i.e., consumers’ sense of belonging, flow experience, urge to purchase, addiction, and impulse purchase). The mediating role of flow experience is also examined in this study. Findings, implications, and directions for further research are also presented in this study.     

浅析混凝土搅拌站的防雷

近年来,我市因雷击而导致搅拌站系统瘫痪停产、影响工程进度的事件时有发生,在针对混凝土搅拌站配料秤的实际检定工作中,也常发现配料秤的称重传感器因雷击损坏而影响计量准确性。因此,对混凝土搅拌站防雷的研究具有重要意义。本文阐述了雷电对混凝土搅拌站的主要危害,分析了混凝土搅拌站常见的雷击原因及其防护措施,旨在引起生产方、安装方以及使用方对混凝土搅拌站防雷的共同重视。     

广西箭猪坡矿床首次发现的石英脉型锡矿体特征及 锡石微量元素地球化学意义

箭猪坡矿床是丹池成矿带南端的一个以铅锌锑为主的矿床，随着2012-2014年在箭猪坡矿床钻孔中石英脉型锡矿体的首次发现，打开了箭猪坡矿床新的找矿空间。新发现的锡矿体矿石矿物组合类型主要为锡石+闪锌矿+脆硫锑铅矿+黄铁矿+石英及锡石+脆硫锑铅矿+石英+方解石。箭猪坡矿床锡石呈自形-半自形粒状，锡石粒径多在0.1～0.2mm，少数0.02～0.05mm，分布在含硫化物的石英脉裂隙中。物相分析显示箭猪坡矿床锡主要赋存在锡石中，锡石物相占83.33%～100%。阴极发光（CL）图像显示箭猪坡矿床中的锡石经历了两期结晶作用：早期锡石（Ⅰ）和晚期锡石(Ⅱ），早期锡石CL荧光亮度较小，呈暗灰色至黑色；晚期CL荧光亮度较大，呈白色至浅灰色。锡石单矿物SnO2含量91.623%～96.288%，平均94.03%，杂质主要有Fe、W、In等，其中FeO含量0.02%～0.52%，WO3含量多在0.02～1.34%，In2O3含量在0.476%～0.954%，Sn与FeO、In2O3呈负相关，锡石中FeO、WO3、Ta2O5、Nb2O5、MnO含量指示箭猪坡锡形成于中低-中温热液环境，成矿热液来源于高度分异演化的花岗质岩浆。通过与大厂矿田西矿带上部脉状锡矿体的类比分析，具有相似的成矿条件及矿物组合，推测所揭露到的脉状锡矿（化）体相当于西矿带上部脉状锡矿（化）体，而下部的网脉状、似层状锡矿体尚未揭露到，由此预测箭猪坡矿床深部找矿空间及找矿潜力大。     

Development of the method of production of the ultrafine macrohomogeneous composite powder

ABSTRACT

A method of ultrafine macro-homogeneous composite powder – B₄C–ZrO₂ production using a planetary mill was developed. From the macro-homogeneous composite high-density ceramics, B₄C–ZrB₂ was produced by the method of reactive sintering (in situ) at 2000°C under the pressure of 41–42?MPa. The effect of ZrO₂ grain size and of its distribution in the matrix on the consolidation parameters, and the microstructure of the obtained ceramics was studied.     

Inhibition of stress corrosion cracking in 304 stainless steel through titanium ion implantation

The effects of titanium ion implantation on the stress corrosion cracking (SCC) behaviour of 304 austenitic stainless steel were studied. Slow strain rate tests (SSRTs) were conducted on 304 steel in air and in 5?wt-% NaCl solution. The microscopic effects of ion implantation were evaluated by Stopping and Range of Ions in Matter Procedures (SRIM). Fracture morphologies and microstructures were investigated by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The fracture surfaces illustrate that ion implantation significantly inhibits the corrosion pits that initiate SCC. A dense passive film, which inhibits SCC, was formed during the ion implantation process. SCC initiation was restrained due to the dense dislocation nets that were generated by titanium ion implantation.

Highlights

• Ion implantation inhibits SCC susceptibility.

• The lack of Cr at the grain boundary leads to the expansion of SCC along the grain boundary.

• Implantation-induced damage leads to high-density dislocations.

• The surface was amorphised due to high-density dislocations.

     

Solution combustion synthesis of cerium oxide nanoparticles as corrosion inhibitor

In this study, combustion synthesis of cerium oxide nanoparticles was reported using cerium nitrate hexahydrate as starting material as well as urea, glycine, glucose, and citric acid as fuels. The influence of fuel type on structure, microstructure, band gap, and corrosion inhibition was investigated. X-ray diffraction (XRD) patterns and scanning electron microscopy micrographs showed that CeO₂ nanoparticles with different morphologies were obtained depending on the fuel type. Microstructural changes from unreacted gel to sponge-like morphologies were resulted by varying the fuel type from urea, glycine, and glucose to citric acid. In addition to Ce–O bonds, Fourier transform infrared analysis showed carbon bonds of carbonaceous compositions from incomplete combustion which were declined during combustion reaction. Furthermore, corrosion analyses showed that samples synthesized using urea fuel released the most Ce⁺⁴ ions and could have better protection than other samples.     

聚乙烯醇/牛I型胶原支架材料的制备及评价

研究了一种聚乙烯醇(PVA)和胶原(COL)复合支架材料的制备方法。采用氨基硅烷对PVA海绵表面进行了氨基化修饰后，通过戊二醛溶液交联牛Ⅰ型胶原(COL)，最后通过赖氨酸溶液封闭，获得一种PVA/COL复合支架材料。采用扫描电镜(SEM)、X光电子能谱仪(XPS)、傅里叶红外光谱(FT-IR)等手段对支架材料的理化性能进行表征，并通过细胞实验对支架材料的生物学性能进行评价。结果表明，经过COL修饰的PVA孔隙率为21.33%，平均孔径为168.68 ?m且均匀分布，支架材料接触角为20.03°。对支架材料的生物学评价结果表明C3A细胞在复合材料上黏附良好，优于PVA组；CCK-8增殖检测结果表明细胞在复合材料上呈增殖生长趋势，与对照组PVA相比差异显著(P?0.01)。将PVA和COL复合制备得到的支架材料具有良好的理化及生物学特性，具有广阔的应用前景。